Tuesday, April 20, 2010

Since alot of the detail was missing on the thermal cast of the torso bely area, i decided to add most of the included resin belly plate. Using a compass and xacto, i cut out the inner circular area. This would then leave a lip around which i could mount the belly plate from the inside.

The center of the resin plate was routered out to allow a speaker to be added. I trimmed the outer diameter down quite a bit so it would line up easier.

I then used a belt sander to remove most of the thickness to the resin cast piece.

The mounted resin belly plate.

No comments:

Post a Comment